1120 CHEMICAL PROCESS. Basic Module

HIGHER TECHNICAL EDUCATION TEXTILE ENGINEERING CHEMISTRY CHEMICAL ENGINEERING PROCESS ENGINEERING PETROLEUM TRAINING CENTER INTERNATIONAL CENTER FOR TECHNICAL TRAINING, DEVELOPMENT AND RESEARCH TECHNICAL AND VOCATIONAL TRAINING INDUSTRIAL CHEMISTRY CHEMISTRY ENVIRONMENTAL

Expansions

PLC

PLC Industrial Process Control

ECL

EDIBON Cloud Learning

FSS

Fault Simulation System

ICAI

Interactive Computer Aided Instruction Software

ELK

EDIBON Software Development KIT, Powered by NI LabVIEW™

Exercises and guided practices

GUIDED PRACTICAL EXERCISES INCLUDED IN THE MANUAL

Calculation of the flow by means of the orifice plate.
Calculation of the flow through a measurement of the static, dynamic and total pressure with an adjustable orifice.
Measurement of machine performance in terms static and total pressure, and motor input power, as an inlet flow function.
Introduction to the scaling similitude law.

MORE PRACTICAL EXERCISES TO BE DONE WITH THE UNIT

Sensors calibration.
Calculation of the characteristic curve of the axial fan at a constant speed according to the flow used by the adjustable aperture.
Study of the axial fan regulation varying its turning speed.
Study and comparison of the practical results and the results calculated by the students.

SUPPLEMENTARY EQUIPMENT

Available

11.1.9.- ION EXCHANGE AND CORROSION

EEC

Corrosion Study Unit

The Corrosion Study Unit, "EEC", allows the corrosion simultaneous study up to eight corrosion cells. This unit allows to study several conditions that influence in the corrosion processes. Each sample for the test is put in such away that...

COMPUTER CONTROLLED DEEP BED FILTER UNIT - EFLPC

EFLPC

Available

11.1.11.- FILTRATION, SEDIMENTATION AND MIXING

EFLPC

Computer Controlled Deep Bed Filter Unit

The Computer Controlled Deep Bed Filter Unit, "EFLPC", allows us to filter a fluid in order to eliminate particles in suspension, to have it in more adequate conditions for its subsequent use or consumption.The pump takes raw water from one of the...

Available

11.1.9.- ION EXCHANGE AND CORROSION

EII

Ion Exchange Unit

The Ion Exchange Unit, "EII", is a self-contained unit composed by a panel, where two transparent columns are situated in order to put anionic and cationic resins, and also a spare column and a pump, which supplies the efficient from the tanks...

EMLS

Available

11.1.11.- FILTRATION, SEDIMENTATION AND MIXING

EMLS

Liquid/Solid Mixing Unit

The Liquid/Solid Mixing Unit "EMLS" is made up of a main support frame, in which a dynamo brake motor of adjustable speed and mechanical connections are installed. Diverse types of agitators can be coupled to the motor.The motor with the above...

SBANC

Available

11.1.7.- DRYING AND COOLING

SBANC

Computer Controlled Tray Drier

The Computer Controlled Tray Drier "SBANC" is a laboratory scale unit designed to study fluid mechanics, surface chemistry, solids structures and mass and energy balances related to the drying process.It consists of a tunnel, several trays where...

SSPC

Available

11.1.7.- DRYING AND COOLING

SSPC

Computer Controlled Spray Drier

The Computer Controlled Spray Drier, "SSPC", allows to study processes that involve aqueous emulsions, solutions, suspensions andcolloidal solutions.Peristaltic pump delivers the liquid sample from a container through a small diameter jet into the...

Available

SERVICES MODULES

TGV

Steam Generator (3 kW)

It is an electrically heated steam generator (3 kW electric resistance). The resistor has an internal thermostat at 150ºC.This type of generator produces steam for an operating pressure of 0.9 bar, with a maximum pressure of 2 bar.The maximum...

Quality

AFTER-SALES SERVICE

FOR FURTHER INFORMATION, CONTACT US