1240 FOOD TECHNOLOGY (OIL). Basic Module

HIGHER TECHNICAL EDUCATION FOOD ENGINEERING ENGINEERING FOR AGRICULTURAL INDUSTRIES AGRICULTURAL ENGINEERING INTERNATIONAL CENTER FOR TECHNICAL TRAINING, DEVELOPMENT AND RESEARCH TECHNICAL AND VOCATIONAL TRAINING FOOD TECHNOLOGY AGROINDUSTRY
Ask for information

Expansions

PLC

PLC Industrial Process Control
ECL

EDIBON Cloud Learning
FSS

Fault Simulation System
ICAI

Interactive Computer Aided Instruction Software
ELK

EDIBON Software Development KIT, Powered by NI LabVIEW™

Exercises and guided practices

GUIDED PRACTICAL EXERCISES INCLUDED IN THE MANUAL

  1. Preparation of solutions.
  2. Analytic valuation techniques.
  3. Filling of the column.
  4. Batch operation. Continuous operation.
  5. Obtaining the McCabe-Thiele diagram. Without reflux.
  6. Obtaining the number of plates. Without reflux.
  7. Efficiency calculations. Without reflux.
  8. Variation of the composition of the distilled product: constant reflux ratio.
  9. Constant composition of the distilled product: variation of reflux ratio.
  10. Constant composition of the distilled product: constant reflux ratio.
  11. Continuos feeding of the column.
  12. Mass and energy balances across the system.
  13. Plates fluid dynamics studies, including load loss and column flooding.
  14. Study of the feed temperature effect on the continuos processes.
  15. Calculation of the theoretical number of floors in the plates columns, and the equivalent height of the theoretical floor (HEPT) in the Raschig rings columns.
  16. Pursuit of the temperatures in all plates in the column (Plates columns).
  17. Study of the rectification efficiency at different pressures.
  18. Effect of feed pre-heat.
  19. Effect of feed position.
  20. Demonstration of azeotropic distillation.
  21. Work different heating contribution with regulation by the computer.
  22. Studies of heating interchange in glass refrigerators.

MORE PRACTICAL EXERCISES TO BE DONE WITH THE UNIT

  1. Dosing pump calibration.
  2. Temperature sensors calibration.
  3. Flow sensor calibration.
  4. Pressure sensor calibration.
  5. Study of PID controls.

Quality

AFTER-SALES SERVICE

Ask for information