WIT-KNX-BC Практики проводки жалюзи с KNX

РУКОВОДСТВО ПО ПРАКТИЧЕСКИМ УПРАЖНЕНИЯМ ВКЛЮЧЕНО В РУКОВОДСТВО ПОЛЬЗОВАТЕЛЯ

1. Basic Integration of the Blinds Control System:

• Connection of the electrical distribution box for KNX devices in the blind control system.
• Application of wiring techniques to ensure a safe installation.

2. Connection of the KNX Room Controller:

• Integration of the KNX room controller for centralized blind control.
• Configuration of functions and programming of scenarios.

3. Connection of the KNX Binary Input Module:

• Connection and integration of the KNX binary input module to detect the status of the blinds.
• Programming of actions according to the detected status.

4. Connection of KNX Binary Output Module for Blinds Control:

• Connection and configuration of the KNX binary output module for the effective control of the blinds.
• Adjustment of response times and configuration of positions.

5. Use of KNX brightness sensors:

• Connection and integration of KNX brightness sensors for automatic adjustment of blinds according to lighting.
• Programming of thresholds and conditions.

6. Connection of Push Button Module for Manual Interaction:

• Integration of KNX pushbutton modules to allow manual interaction with the blinds.
• Programming of up, down and stop functions.

7. Shutter Motor: Connection and Integration:

• Connection and programming of the shutter motor.
• Evaluation of system performance under various conditions.

ETS Project Creation and Topology Definition:

8. Creation of a New Project in ETS:

• Development of a new project from scratch with ETS software.
• Definition of general characteristics and establishment of the basic topology of the KNX system.

9. Definition of the Bus Topology:

• Configuration of the KNX bus topology.
• Identification of devices and establishment of physical addresses.
• Application of good design practices.

10. Physical Address Assignment:

• Assignment of physical addresses to KNX devices in the project.
• Follow-up of addressing standards and recommendations.

11. Topology Verification:

• Verification of configuration consistency.
• Compliance with KNX system requirements.

KNX Device Diagnostics:

12. Use of Diagnostic Tools:

• Use of diagnostic tools in the ETS software to verify communication and status of KNX devices.

13. Communication Testing:

• Performing communication tests between KNX devices and the bus.
• Identification and resolution of possible connection problems.

14. Telegram Analysis:

• Analysis of telegrams sent and received by KNX devices.
• Identification of possible errors or interferences in the network.

15. Error Diagnostics:

• Diagnosis and troubleshooting of configuration or connection errors in KNX devices.
• Use of diagnostic tools available in the ETS software.

16. Event Logging:

• Use of event logging functions to monitor and analyze the behavior of KNX devices under different operating conditions.